-
I have a small ESP-IDF Project for a Lilygo T3 S3 board (SX1276). I'm trying to receive data from Ecowitt WH51 sensors (868MHz FSK, various sources claim 868.35MHz should be used for best results). I …
-
Is is possible to use the 868mhz versions of the CC1101 with this library?
-
Hi I installed tinyGS to my Heltec lora32 v3 board sx1262 lora radio but with 868MHz
I configuration there is no option for 868MHz only 433MHz
![Screenshot_20240415-122906](https://github.com/G4lile…
-
**Describe the problem you have/What new integration you would like**
It seems to me there is no support for a 868 MHz tranceiver to receive and emit custom signals.
**Please describe your u…
-
**What new integration would you wish to have?**
Would it be able to add RF Transceiver 868MHz CC1101?
*If possible, provide a link to an existing library for the integration:**
https://github.…
-
Hello,
Very impressed about the project.
I’ve seen it can be used to up to 900mhz but in practice can i measure the impedance at 868mhz?
-
Hello.
I have got a CC1101 868 Mhz and a nodemcuv2. wired them accordingly the readme
Last 2 days i have been trying to sniff some PIR sensors (868mhz) with no success.
at this point i dont e…
-
When receiving 868MHZ, how to block 433.92MHZ and how to set it? After the remote controllers of 433.92 and 868MHZ are sent, 868MHZ is received normally, and it is impossible to determine which freque…
-
Hi Theo, i've come across your repo.
Just a question regarding the hardware you recommend.
You recommend a lora 868mhz esp32, but the ts-ft002 is sending via 433mhz. is the esp the correct one or …
-
I'd like to be able to use my RTL-SDR dongle to decode 868Mhz messages from my Hoymiles HMS solar inverter.
There are two implementations for codecs using the CMT2300A chip included in these two pr…