-
I'm having the same problem as an earlier user. My error message is slightly different though: `Invalid adxl345 id (got ff vs e5)`
I'm using Rampon v04 because my Klipper version is v0.12.0-289 (bu…
-
Can I use adxl345 to do input shaping and if it is possible how would i do it.
-
there is no wiring diagram for the adxl345 or pinout for this board available
-
После подключения акселерометра по приложенной статье столкнулся с ошибкой:
```
!! Invalid adxl345 id (got 0 vs e5).
```
Это связано с описанной в статье проблемой spi по 24 пину. WiringOP с коман…
-
-
![image](https://github.com/user-attachments/assets/19f3fb9b-cdee-4d45-a59e-a8bc99fcab70)
Hi after updating to V1.1.0-45-g2ec826dd i start to get this error.
Any ideas?
-
Connecting an ADXL345 to SPI1 on my Manta M8P causes the MCU to not boot. It seems like the bootloader is conflicting with some other device on SPI1 on boot.
Can anyone confirm if there is any othe…
-
Hello,
I'm using your library for the ADXL345.
The connection with ESP32 is as follows:
SCL -> GPIO_22
SDA -> GPIO_21
The problem is that during the adxl345_init there are these errors:
- …
-
**Purpose**
To confirm the frame rate when running RaspBilliard on Raspberry Pi with ADXL345.
**How to evaluate**
1. Read acceleration data from ADXL345 (SPI/I2C Bus) and then calculate the velocity …
-
the accelerometer shall put the device in a proper sleep state in order to preserve power when no movement is detected.
for this the ADXL345 can trigger interrupt events which the micro-controller has…