-
Hi,
great work, thank you.
I would like to give it a try for my own 65C02 homebrew computer I‘m about to assemble.
But I‘m a bit lost regarding the EPM7128.
Would you please explain how to pr…
-
Hi team,
I am using LE 3.9.0 on windows and an Altera DE0 Board.
The attached file shows the usage of a Port I/O component with a single pin.
When trying to synthesize the following message sh…
-
Sir,
I have an ALTERA FPGA Cyclone II EP2C5T144 board. Is it possible to use this with LinuxCNC-RIO for real-time I/O? If yes, could you provide any guidance or steps to make it work?
Thanks!
-
Hi Raj,
I've build image without adding any custom change in yocto project. I'm not able to boot image in altera board.
[core-image-minimal-cyclone5.tar.gz](https://github.com/user-attachments/fil…
-
### Prerrequisitos
(Marcar colocando una `X` entre los corchetes los ítems que ya hiciste, así: `"[X]"`)
* [X ] Leí las reglas del foro (https://github.com/IIC2233/Syllabus/wiki/3.-Reglas-del-…
-
Is posible to create a firmware for -15n model? I don't know if this speed grade can be used in first place but I tried to upload .pof file and I got an error.
Thanks in advance.
-
I'm using Altera Arria10 hps, when I install the driver with debug mode define DEBUG, no massage showing or new device to i2c devices
/sys/bus/i2c/device/0-0020 not showing,
@lainwir3d requestin…
-
**_Reported by Robert Beatty:_**
Zephyr shall support Alterra MAX10.
- [ ] GH-511: create abstraction layer to directly use Altera HAL drivers for Nios II IP blocks
- [ ] GH-450: tcf: add support fo…
-
**_Reported by Robert Beatty:_**
Zephyr shall support Alterra MAX10.
- [ ] GH-473: create abstraction layer to directly use Altera HAL drivers for Nios II IP blocks
- [ ] GH-412: tcf: add support fo…
-
Altera a garantia do serviço e atualiza no banco.