-
We were requested via email to consider providing support for the pdf5 plugin.
-
The transmission power is already very good with the small stub antenna.
To increase the reception power I built a dipole antenna. It works really well, the performance is noticeably stronger and no…
-
Hi,
i am not an expert for CSS, especially not for paged media. That's why i am not sure whether this is a bug, or a misunderstanding on my side.
This report is motivated by an [issue with DocBoo…
-
### Hardware
ESP32, ESP32-C3
### Firmware version
2.4.5
### Application version
2.4.5
### What happened? What did you expect to happen?
Not sure if it's a bug but wifi signal is -91dBm (reporte…
-
Hello,
my intention is to improve the connectivity of another ESP32 WLED installation in my garage.
Therefor I'm testing the nat-router since a couple of weeks in my mesh WiFi network, consisting o…
-
I am trying to use an Oxygen Transformation Scenario to convert DITA to PDF using the Antenna House processor on my hard drive. But, I keep getting this error:
Transformation failed. C:\DITA-OT-3x…
-
Euclid's antennas are connected to their router with Cat 5 cables, other houses' might be too. Also, some of the PoE boxes we're using are 100 Mbps. These should be checked at all houses.
clonm updated
4 years ago
-
Antenna House Formatter implements `image-resolution` from the last GCPM WD that had it:
* https://www.antenna.co.jp/AHF/help/en/ahf-ext.html#axf.image-resolution
* https://www.w3.org/TR/2010/WD-css…
-
I have recently soldered my SX1276 modules to my custom board which has U.FL connector with U.FL to SMA cable connected to it and SMA has 5dB antenna connected to it.
SX1276 is connected to ESP32 usi…
-
For next revision, can you add NFC components. (eg https://www.nxp.com/docs/en/nxp/data-sheets/PN532_C1.pdf)
Could then use Watchy with other NFC devices, eg https://arduinogetstarted.com/tutorials…