-
### Description of the issue
Since upgrading to 1.39.0-1 I cannot access Zigbee2MQTT's frontend, getting "502: Bad Gateway" instead. Other addon frontends are accessible via ingress. There's nothin…
-
### The problem
Hi,
My Home assistant is configured to use Celsius unit. But after every restart It goes back to Fahrenheit unit.
The devices concerned are :
**MQTT**
- Temperature and humi…
-
When pressing the call button in aqara app it is shown OK in the app but no sound from the doorbell speaker. Can it be caused by your firmware? Is there any way to roll everything back to stock?
-
I've enabled telnet on my EU m2 hub and set up environment. I see it is connected via telnet and MQTT
![image](https://github.com/niceboygithub/AqaraGateway/assets/3011471/96f9b1cb-2542-49f8-9686-624…
-
### What happened?
I have an Aqara ZNCLDJ14LM cover motor and I'm receiving these errors:
> Payload is not supported (e.g. open, closed, opening, closing, stopped): stop
### What did you expect t…
-
Hi everyone,
I spend much time trying to configure Aqara Double wall switch.
Now i have left button as switch for my light that works well, but i can't configure the right button as statelessProgram…
-
Hi.
I have an Aqara M1s with a door sensor conneted to it, and the gateway have no internet after 8PM and before 8AM (so on the evenings). So before 2.2 the devices was unavaiable in this time. On…
-
### Link
https://www.aqara.com/en/product/smart-door-lock-a100-zigbee
### Database entry
"definition":null,"friendly_name":"0x54ef4410004c5112","ieee_address":"0x54ef4410004c5112","status":"s…
-
### Problem description
Light strip is available to add via ZHA directly, however you cannot control the length of the strip. When using extensions on the light strip, standard color temperatures wil…
-
### What happened?
zigbee2mqtt throws an exception when trying to configure my Aqara Smart Radiator Thermostat E1.
Yesterday it was able to read values from the radiator but not write to it. Now,…