-
Normally fuse bits are defined like
```
#define FUSE_SOMETHING (unsigned char)~_BV(some_n)
```
For the list of parts below gcc v12 defines a lot of them *without bit inversion* `~`
```
atmega1…
-
Design constraints:
* Minimize power draw when device is off
* Allow soft power down (warn the OS rather than just cutting power)
* Minimize components
-
This code works great on an ATTiny85. However I need to use the newer ATTiny 1-series chips in my design. I am trying to use the ATTiny1614, but the code will not compile. Many errors, but most simila…
-
### Describe the problem
The Arduino language features are not available after startup.
### To reproduce
- Have no attached boards,
- Start IDE2,
- Select `Arduino Uno` board (can be any),…
-
I am not so sure how difficult it is to add the support of mega0 AVR and Tiny0/1/2 AVR, similar to optiboot_x.
Stretch goal will be to add the support of AVR DA/DB/DD part, similar to optiboot_dx.
…
-
The current "avrdude.conf" has the following description in three places: ".xmega", ".avr8x", and ".avrdx".
```
memory "data"
# SRAM, only used to supply the offset
offset …
-
Normally fuse bits are defined like
```
#define FUSE_SOMETHING (unsigned char)~_BV(some_n)
```
For the list of parts below gcc v12 defines a lot of them *without bit inversion* `~`
```
atmega1…
-
Hi,
your lib looks very promising. Unfortunately there are big problems with it. If I use it with Arduino then the controller always resets.
If I use it in Atmel Studio 7 it always compiles with…
-
pymcuprog returns 0 when an error occurs during programming (e.g. when target disconnected from programmer), but return value should be nonzero for error.
Examples:
No error (return value is 0 …
-
As the title says, i can't seem to change the DAC reference from internal 0.55V. I tried all the options except for the external reference and the full scale output remains 0.548V as measured.
I'm …