-
Writing an hex file with a non zero base (example 0x200, as produced by the Arduino IDE) on Attiny814 results in verify errors, as it is read back from (0x8000), the base address of the flash (pyupdi:…
bitli updated
3 years ago
-
Normally fuse bits are defined like
```
#define FUSE_SOMETHING (unsigned char)~_BV(some_n)
```
For the list of parts below gcc v12 defines a lot of them *without bit inversion* `~`
```
atmega1…
-
I use a Raspberry PI without a Resistor between RX and TX and a level converter between ATmega4809 and the Raspberry.
I got this output:
python3 pyupdi.py -d mega4809 -c /dev/ttyAMA0 -fr -v
INF…
-
It would be nice to see also a PD Trigger with a cheap MCU which allows to set a target voltage, but with
a buck and boost converter on board, so if the target voltage cannot be negotiated, it will b…
-
### Discussed in https://github.com/SpenceKonde/megaTinyCore/discussions/1129
Originally posted by **magoldsm** July 18, 2024
In the attached code, I make continuous calls to analogWrite. Aft…
-
### Describe the problem
The Arduino language features are not available after startup.
### To reproduce
- Have no attached boards,
- Start IDE2,
- Select `Arduino Uno` board (can be any),…
-
I am not so sure how difficult it is to add the support of mega0 AVR and Tiny0/1/2 AVR, similar to optiboot_x.
Stretch goal will be to add the support of AVR DA/DB/DD part, similar to optiboot_dx.
…
-
These warnings pop up when building AVR-LibC device libraries:
```
In file included from ../../../../../source/avr-libc/include/avr/io.h:759,
from ../../../../../source/avr-libc/…
-
The current "avrdude.conf" has the following description in three places: ".xmega", ".avr8x", and ".avrdx".
```
memory "data"
# SRAM, only used to supply the offset
offset …
-
Sometimes when I try to compile my program, I get an error like:
```
C:\Users\\AppData\Local\Temp\ccjGNTgP.ltrans0.ltrans.o: In function `global constructors keyed to 65535_0_MySketch.ino.cpp.o.30…