-
At shsbbs.net at least, with a secure websocket connection, the terminal baud rate emulation is ignored. I'd like to be able to see my scrolling ansis!
-
I had a problem to setup the serial communication with _Serial.begin()_, with the Attiny3224 MCU. After several investigations I found that the problem was the baud calculation. Finally I managed to m…
-
When data is printed at very high speeds from the serial port, the library is unable to receive the incoming message in one go. This is valid for cases where the timeout period is kept short, and the …
-
add to `main_new_driver.cpp`
mn297 updated
2 weeks ago
-
What will be the maximum achievable baud rate? I've seen reports of ~1 MBaud, but for my application 3 or more will be needed. Can it be achieved on RP2040?
-
I set up my zones, had the lights hooked up and just needed to adjust colors, but I had a warning on the bottom that my baud rate was too low for the fps I had set (60).
I went to the configuration…
-
I always bekome this error i tried evrithing
Starting flash new (no backup)!
Now is: Dienstag, 16. Mai 2023 10:36:26.
Flasher mode: BK7231N
Going to open port: COM6.
Serial port open!
Getting…
-
Hi,
When I was using a 15Mbps serial port, I found that I couldn't send or receive. Is the current maximum serial port baud rate supported 2Mbps?
Thank you :)
-
Elkulator exits when encountering UEF baud chunk &117.
In one sense, this behaviour is reasonable, as the Electron does not support 300 baud, so no baud change is possible. However, encountering th…
-
I am running this code on an RPI4b. It used to work and all of a sudden became very unstable. The code is the following:
let port_name="/dev/ttyUSB0";
let baud_rate=115200;
match Seri…