-
Static code scan issues found in file:
https://github.com/zephyrproject-rtos/zephyr/tree/dae79cefaabf63086946a48ccca4094f26f146c8/drivers/sensor/bme680/bme680.c
Category: Insecure data handling
Fun…
-
Hello,
I tried to connect two sensors with Qwiic/STEMMA QT connector, but I can only get readings for one of them at a time:
The sensors are:
- BME688 - bus 0x76
- LTR390 - bus 0x53
The adafr…
-
As to be able to monitor environmental data, in this case temperature, pressure, humidity, and VoCs
## References
- https://learn.adafruit.com/adafruit-bme680-humidity-temperature-barometic-pressu…
-
Just wanted to leave you with a couple of pointers. I have gone down the rabbit hole of trying to understand what Bosch did in their code [a while back](https://taoofmac.com/space/blog/2022/08/19/1730…
-
### The problem
my BME680 sometimes stops working, the BH1750 that is on the exact same wires keeps working however.
Their pins on these sensors are exact reverse so the wires and sda-scl resistor…
-
Hello,
I was wondering if it would be possible to show the pressure at one more precision digit, a.k.a. in hectopascals (with 0, 1 or 2 decimals).
The kPa setting shows the correct pressure, altho…
-
The Bosch BME680 adds an air quality measurement (ohmic) in addition to the BME280's sensor types, could be useful to add support for it in this plugin
https://www.bosch-sensortec.com/bst/products/…
-
Hi,
Is it possible to show the current value of BME680 sensor on the panel? The temperature works already. However BME680 also has pressure, humidity and gas reading.
Thank you.
-
Any interest in adding BME680 sensor support? The BME680 is similar to the BME280 but adds a gas sensor (air quality) measured in ohms
This may be useful for reference: https://github.com/twartzek/…
-
**Describe the problem you have/What new integration you would like**
Please add support for BME860 BSEC esp-idf, because of the framework: arduino i cant run BLE there because it takes up a lo…