-
Had a old board laying around and wanted to try your code on this board.
Atmega32u4 and SX1276
-
Using Arduino IDE 1.8.5 on Windows 10 system.
Attempting to compile LoRaSender example.
Get the following error:
exec: "C:\\Users\\DMD\\Documents\\Arduino\\hardware\\BSFrance-stm32-master/stm32/t…
-
The boards.txt file references a non-existent file. Is there a way to acquire it, or is it unnecessary?
When I try to upload a sketch, I see this error message:
```
Bootloader file specified b…
-
I installed the Arduino 1.8.8 IDE for Linux (Debian scratch, 64 Bit) and installed the https://github.com/BSFrance/BSFrance-stm32/archive/master.zip as mentioned in the Readme.
The gcc-arm-none-eab…
-
Hi
I upload gps sketch to arduino pro mini and its work juts fine. Then i try use DIY lora32u4 whit adafruit board and bsfrance board setup but i allways got error:
Arduino_LoRa_GPS:144: error: …
-
Hi!
Your page is a great resource and help for the MPU-9250. I have been trying for a while to get the MPU-9250 to work with a TM4C123 (Tiva C) via an IIC connection. I get the right answer (0x71) fr…
-
Update: See [further below](https://github.com/lnlp/LMIC-node/issues/45#issuecomment-1173196192) for a more complete description of the workaround.
---
I have observed a bootloop after using the…
-
Hi,
I experience a strange issue with the library: if I put a delay in the loop(), the LoRa module fails to receive almost all packets. I use the delay to simulate some long blocking operations.
I…
GIPdA updated
3 years ago
-
I wanted to use a LoRa Radio Node board with an 328 chip and OTA on the V3 stack. It uses the old LMIC library and joins, but does not transfer messages. Serial stops after:
LMIC-node
Device-id…
-
Hello everyone, I am working with the Lora 32u4ll of BsFrance and a gateway kernel, it works, transmits to Yeap (a lora provider) but the RSSI is very low, around -117 and my lora 32u4ll is very close…