-
When I open simulation projects, especially in FMU settings, that has used pyscal to generate saturation table the Pc-curves is often quite unrealistic. and contains large entry pressures. This seem…
-
Capillary pressure is currently interpolated linearly, while it might make more sense to interpolate this logarithmically.
-
changes to opm-parser
-
I was reading through some of the opm-material codes. Some of the lookup saturations that are used in some of the classes (i.e. EclDefaultMaterial and EclStone1Material) seemed a little odd to me. I h…
-
changes to opm-material
-
change to ewoms
-
**Describe the issue**
For multiphase poromechanics simulations on hexahedral meshes, the memory requirements of the constitutive models (multifluid, relperm, capillary pressure) are huge because of …
-
The plumbing inside the box is connected to boat inlet and boat outlet.
During normal operation, fluid from boat inlet is pumped through the capillary flow cell and pumped to boat outlet.
To re…
-
After scaling the relative permeability end-points of the model, I got the following error at 0 timestep: ```Program threw an exception: Could not find solution for PcEq = 0.0 after 60 iterations.```
…
ghost updated
5 years ago
-
I had a lot of issues dispatching parallel scan jobs from a Jupyter/IJulia notebook (although single parameter set runs in a notebook worked fine). This occasionally seemed to work, but generally didn…