-
Hello,
I bought a LILYGO T-SIM7670G-S3 ESP32-S3 4G LTE Wireless Cellular IOT Devices Low-power Long-range Communication with GPS TTGO Development Board from the Lilygo amazon store. I have tried va…
-
Hello Microchip community,
Hardware: AVR-IoT-Cellular mini, Water level sensors (once Grove seeed connected to I2C, once Endress+Hauser Liquipoint connected to GPIO)
Software: avr-iot-cellular-ard…
-
RFC 1661 outlines the [Discard-Request](https://datatracker.ietf.org/doc/html/rfc1661#section-5.9) with very minimal information. What I have gathered is that it is a frame sent by the sink node as so…
-
Hello,
I am running a small micropython code loop on XBee 3 Cellular LTE-M/NB-IoT hardware, firmware version 11415. Using examples from the digi documentation and GitHub I simply instantiate a XBe…
-
### Current Behavior
When a device with multiple nic cards runs the device agent. It seems as if it causes network issues on the device and the device then starts to try to switch between communic…
-
I set up the AVR IOT Cellular to send via MQTT every 5 minutes and use PowerSaveMode between readings of the MCP9808 and volts. After it had been running for a while I noticed the temperature reading…
-
## Introduction
We need a device driver API to configure and control cellular modems. This RFC will list every individual feature the API should cover, documenting the requirements and rationale be…
-
A common feature in many modern burglar alarm systems is 4G connectivity. Because if you lose your primary connection, either due to power loss or an upstream fiber cut you won't receive any alerts fr…
-
I have a Digi XBee3 Cellular LTE-M/NB-IoT module with a firmware version: 1141A. I am using a 1NCE NB-IOT sim. Preferred network technology is set to NB-IoT Only.
I am following user guide exampl…
-
The Digi LTE-CATM1 XB3-C-A2 supports an option for type of Network, and others may as well.
NB-IoT only (primary) is likely to be lowest battery usage, but will need testing.
This may need to be c…