-
Sorry for raising an issue for this, but I have multiple Charge controllers. You can assign them numbers. I don't see anywhere in the code where it's referencing the unit number (It's 1 by default)
…
-
hello is it possible to get the modbus protocol of the new jk pb, especially the addresses of the battery voltage, current, soc, battery capacity and all the other addresses that are missing in the ya…
-
The Mayfly's Lipo battery solar charge controller chip ([MCP73831](https://www.microchip.com/wwwproducts/en/en024903#additional-features)) has a max output of 500 mA, which is about the 550 mA peak ou…
-
### Core capabilities
- [x] Linux boot
- [x] Kernel
- [x] GPU drivers
- [x] Governors
- [x] UI service
- [x] Audio
- [x] Wifi
- [x] Bluetooth
- [x] LED control
- [x] Sleep
### Controlle…
-
Hello,
At first I want to thank you for this project. It works very well.
As I am new at these kinds of stuff I have a single question. At first: I use two EPEver Tracer 10415AN, combined with a EPE…
-
It can charge every other slot except those in the inventory. Is there a way to enable that feature as I don't want to have to keep on switching out flux capacitors during a battle.
-
### Category
Other
### Hardware
Other
### Firmware Version
2.5.x
### Description
I'm seeing increased reports of "Solar station doesn't wake up after getting power". Guess we have…
dm5tt updated
1 month ago
-
Hi,
using the mqtt method I got more sensors out of the WiCan then the profile has.
I have:
- Range
- Charge State
- Plug State
- Remaining Charge Time
- Outside Temp
How can I contribute …
-
Hi, this may be off topic, but out of all your inverter integrations, this one is the most similar for the srne inverter, and some settings works better compared to the pdf protocol doc. I was able to…
-
I tried to create a branch so I could push this directly. If you want to add it these are confirmed to pull the additional values from an MPPT charger.
```
enum VE_DIRECT_DATA {
VE_DUMP = 0,
V…