-
*Sent by (dccextended@gmail.com). Created by [fire](https://fire.fundersclub.com/).*
---
## Liam created a ticket
Name: Liam
Email: liamh2046@outlook.com
Timezone: 0
Software: EX-CommandStatio…
-
I'm working on my DCC turntable decoder.
Decoder works fine and responds correctly.
However using the examples from here:
https://dcc-ex.com/ex-commandstation/accessories/turntables/dcc-turntable…
-
I have experienced problems trying to use an accessory address over 252. I do not get the same problem using a different command station. I do not have access to another CANCMD so cannot check whethe…
-
Hi there,
First of all, this is a really nice project.
I'm the author of DGEngine (https://github.com/dgengin/DGEngine). I used your DCC decoder (not yet committed) and would like to add it to D…
ghost updated
5 years ago
-
*Sent by (@JohnnyGame3). Created by [fire](https://fire.fundersclub.com/).*
---
Hello, I have a problem and would be happy to get some support.
I am a student from Germany and I am currently doing …
-
Hi, I have been looking into your nice work about DCC decoders to be able to digitalize an old Märklin M layout. I am looking into utilizing every single i/o pin of an Attiny85, including the reset pi…
-
@pabender
XpressNet Monitor icorrectly displays address for Ops mode programming for Accessory decoder and Extended Accessory decoder packet.
. Created by [fire](https://fire.fundersclub.com/).*
---
## Jeff created a ticket
Name: Jeff Law
Email: jdlaw75@gmail.com
Timezone: 12
Software: EX-CommandStatio…
-
The latest RailCommunity DCC spec includes support for long Consist addresses, stored in CV19 and CV20. This is already supported by the latest firmware in ESU decoders.
The current CBUS consistin…