-
Hi friends,
Is it posible to use DRV8825 stepper driver with gobot?
Thank you, very much.
-
I installed 3 drv8825, x,y and z directions. Works great.
But if I am putting a drv8255 in the extruder place the usb connection to repertier host crashes a lot. I am using the newest version here. A…
-
I was wondering if these settings are correct. So with step doubler 16000f / 320 steps/mm = 50 mm/s would be the printing speed.
But what if I would like to print faster and have travel speed of 100…
-
Hello, I got some TMC5160 v1.2, can they be used to replace drv8825?
-
I was building a robot inspired by what you were inspired by, but with your code I managed to balance it, but I couldn't control it via WIFI, as it always falls, do you think the DAC soldier on the DR…
-
I just received the board, installed the firmware, installed correct pins and installed DVR8825 drivers but I get no movement from the stepper motors, not even a slight resistance when turned by hand.…
-
**Application version**
Cura 4.3
Cura 4.2
**Platform**
Windows 10
**Printer**
Hephestos with SKR 1.3
X and Y: TMC2208
Z and Extruder: DRV8825
**Reproduction steps**
Just prin…
-
Hello MK team!
I hope you can hell me here.
### Issue description
G28 command is not working. If I send it in the terminal the board answers ok and the axis current position but nothing moves.
…
-
Hola, compre unos ST820 en Aliexpress.
Cómo puedo cargar un nuevo firmware?
Necesito verificar y chequear el pin enable funcione igual que el drv8825.
Me podrían ayudar?
English
Hello, bu…
-
I would like to use it with DRV8825 or with an A4988.
Thanks so much for the software