-
@thegroove Request esphome-zbbridge compatibility with new ZB-GW03 eWeLink Ethernet Zigbee Gateway (wired network bridge).
https://templates.blakadder.com/ewelink_ZB-GW03
ZB-GW03 eWeLink Etherne…
Hedda updated
2 years ago
-
Im unsure where to report this, as I dont know is causing it.
I have an eachen ewelink zigbee hub (ethernet) flashed with tasmota (tried 9.5.0 and 9.5.0.3) and ncp-uart-nsw_6.7.9_115200 zigbee firm…
R5fan updated
2 years ago
-
Hi, I have a few non Sonoff devices, basically 1,2 & 4 channel 7-32V relay boards from eachen.cc that are not being shown by the library.
Seems the appid is for Sonoff specific devices only.
Was…
-
Hi,
I'm using an Eachen (eWelink) Zigbee Bridge Pro ZB-GW03 with syssi EspHome firmware [https://github.com/syssi/esphome-zb-gw03](https://github.com/syssi/esphome-zb-gw03) within Home Assistant usi…
-
Zigbee is becoming the de facto standard in home automation. It would be great if `OpenMQTTGateway` could support this protocol. Below I have a write up about the most promising solution at the moment…
-
https://github.com/AlexxIT/SonoffLAN
[HACS](https://hacs.xyz/) > Integrations > Plus > SonoffLAN (v3.3.1) !!! must be this version to avoid devices being unavailable in later versions
Configuration…
-
**Describe the problem you have/What new integration you would like**
Please consider looking at using Sonoff ZBBridge as a WiFi-connected networked Zigbee serial adapter for projects like ZH…
Hedda updated
10 months ago
-
I am totally new to ESPHome, found this project and have few question about that. My hardware is drive with one button - connected in parallel with ESP relay GPIO12, and one input as "close" sensor GP…
luzik updated
5 months ago
-
Please consider porting ESPurna to the new Sonoff Zigbee Bridge (Sonoff ZBBridge)
- https://www.itead.cc/sonoff-zbbridge.html
Itead has just launched Sonoff ZBBridge as an inexpensive Sonoff Z…
Hedda updated
2 years ago
-
From last update sonoff dw2 door sensor cannot change state if Home Assistant is up and running from some times. For recognize the state i have to reboot Home Assistant