-
i really like the homing config , but i havent been able to make btt eddy work with it . tried tinkering with it but its beyond me XD
-
I have tried everything but I can't get the eddy adaptive mesh to work, I imagine it is a problem with the sovol macros, I have tried to adjust them but I still can't solve it, it would be great to ha…
-
-
Has anyone gotten the 5m to work with an eddy sensor?
https://github.com/bigtreetech/Eddy/
It's integrated into klipper mainline, but I know we are running a few revs behind. https://github.com/Kl…
-
https://biqu.equipment/products/bigtreetech-eddy
Further analysis needs to be made to see how it would hook into the can bus system EBB36 EBB42 CAN or I2C Port Board before creating a an adapter bra…
-
I am inclined to buy a Edd probe and mod my toolhead.
What I don't 🙂 like is the need to route another USB cable through the umbilical.
I had an idea how to circumvent this:
There exist mini PCB'…
-
I have issues getting my Btt Eddy (USB) to work.
Ive made a fresh install of DietPi and Klipper, Moonraker, Fluidd, Klipperscreen, Crowsnest (via kiauh) to make sure my Virtual Enviroment runs within…
-
When I run `PROBE_EDDY_CURRENT_CALIBRATE_AUTO CHIP=btt_eddy` , I get the error Failed calibration - frequency not increasing each step .
I followed the setup guide but I can't find a solution.
…
-
Hi, I notice that you updated the readme 9 hours ago but the klipper main now supports the eddy. At least it is running on my printer with a couple of amendments, ie data_rate not required (And fails …
-
I spent many hours to get Eddy Coil working on two different 3D printers with IDEX configuration, to no avail. It doesnt let me calibrate the eddy with the PROBE_EDDY_CURRENT_CALIBRATE CHIP=btt_eddy c…