-
I'm trying to compile and upload the firmware from Arduino IDE to an IdeaSpark esp8266 (`NodeMCU 1.0 (ESP-12E Module)`) device (not sure if it's supported in the first place).
First problem encount…
-
hi there, treid to compile today using the Arduino IDE but gut this error:
```
\RFID522-Door-Unlock-master\EEPROM\EEPROM.ino: In function 'boolean checkTwo(byte*, byte*)':
\RFID522-Door-Unlock-ma…
-
**FPP Version and Hardware**:
FPP 8.0 running on BBB
**Describe the bug and Steps to reproduce**:
1. Flash FPP BBB 8.0 zip to sd card.
2. boot
3. does not boot, or pull ip.
4. Does not fix…
-
According to PonyProg [website](http://www.lancos.com/prog.html) USB support have been on the TODO list for quite a while now. Issue #3 mentioned that it was the was first priority after porting it to…
-
Wanted to inquire about what does the rnodeconf utility refers to when it means "fail to provision", unsure of where in the manual the documentation for this is, there was a thread here, but following…
-
Running `calibration_reader.py` on my OAK-D in Windows fails immediately with
```
Traceback (most recent call last):
File "calibration_reader.py", line 17, in
M_rgb, width, height = calibDa…
-
**Problem:**
On chinese CAS3 keys (IDE shows PCF7945 signature, transponder chip marking 26A0700, picture below), communication is very unstable. For example reading Block 2 takes various tries for r…
-
```
What steps will reproduce the problem?
I modified the sample code somewhat to show what I was getting in my
own sketch. Below is the updated sample.
/*
EDB_Simple.pde
Extended Database Libra…
-
How to install firmware?
-
### The problem
i have tried a lot of different ways but none of them work on windows and on a raspberry pi
- via https://web.esphome.io/ able to install and configure wifi but no logs or device…