-
I'm pretty new to that, so excuse me if there is already an answer in the other issues, but so far, I can't solve the problem.
When I try to deploy a flow using the enocean listener I'll emediately…
t0m82 updated
5 years ago
-
Im running Openhab2 installed with Openhabian on a Raspberry Pi 3 B+ with both an Ember Zigbee and USB300 Enocean dongle attached. There is Symlinks for both.
When I start the Enocean discovery Proc…
-
Installation Onboard Chip EnOcean USB 300 (OEM) on PI 3
WARN install No prebuilt binaries found (target=12.13.0 runtime=node arch=arm libc= platform=linux)
In file included from ../src/./serialport…
-
ich strebe gerade an, ein Deuta-Controls BL-201-00-868 UP Broadcast Modul über meinen EnOcean Pi und ihrem node-enocean Modul anzusteuern.
Ich habe ein Testscript (s.u.) geschrieben, das ich aufrufe…
-
### What happened?
Hello
So i'm in a bit of a pickle atm. I'm currently running `1.36.1`, but there is a fix in `1.40.1` for something else i would like. I digress.
But all versions past `1.3…
-
Hi there,
I tried getting your Quickstart example to work without success and after making several changes.
Setup:
- EnOcean USB 300 DC attached at `/dev/ttyUSB0`, BAUD rate of `57600`
The st…
-
I have a question and I hope someone can help me. I have a Eltako setup with the FBA14 RS485 bus coupler, which I've hookedup to my raspberry pi via USB. This setup works, because I've tested it with …
-
I put an Enocean TCM 310 on my PI 4. LED lights up green. the plug in installed. what do I have to do now so that my switches are recognized?
-
-
Hello Holger,
There seems to be a new issue with serial port and the enOcean input and output nodes.
Before the update this was all working fine.
I have reinstalled node-RED and updated your n…