-
### The problem
Since the latest Home Assistant update, which I believe is version 2024.11.x, I've been experiencing an issue where some ESP devices show as "unavailable" after restarting Home Assist…
-
### The problem
The "early_pin_init: false" does not work with light component.
In this case the relay toggles "off" for a short time at boot (when relay was "on" at boot):
```
esp8266:
…
-
This family of boards ([example on AliExpress](https://www.aliexpress.com/item/32919575201.html)) is extremely common, they feature an ESP-01 that communicates with a STM8S103F MCU on the board throug…
xates updated
2 years ago
-
Hi, i'm using your latest thermostat firmware and works very good!
I trying to create a device for homekit Sensor.
Ravensystem have this one in his repo Ravencore, but is with relay. I mean device t…
-
# HW-655 WiFi RELAY
Probably the low end of esp relay possible...
 be usin…
-
My printer currently has LED Strips on it's frame I mostly use them for time-lapses or when I watch the prints overnight via Octoprint.
Since HA knows the status of the printer I could add a D1 mi…
-
During boot the relay turns on then off then on again.
any help would be much appreciated
-
### The problem
Setup: ESP32 NodeMCU, with ESPHome 2022.2.4 installed. GPIO 33 connected to Wemos D1 relay shield. Active High, attached to NO. This is to open a door on HA command.
The same setup…