-
Any thoughts on supporting the new Blind Tilt?
I had hopped that it would work as a curtain, but no such luck that I can tell.
I'm happy to be pointed in the right direction and make attempts to…
-
**Describe the problem you have/What new integration you would like**
The Lyligo T5-4.7inch is a great e-paper module based on an ESP32. It has a resolution of 960*540, 16 gray level and support …
-
Do you think it would be possible to flash an alternate (open source) firmware on this device, for example Tasmota? [This device](https://templates.blakadder.com/sonoff_ifan02.html) looks rather simil…
-
### What happened?
my cover already fully opened and appears fully close at matter , if i set position to 80% then at matter appears opened to 20% , its working opposite way
### Your configuration
…
-
Hi, thanks again for the tons of work you have put in this blueprint and for your helkp with an issue I had previously.
I am having an issue with opening the blinds in the morning. I have set time …
-
Hello,
I have two elero blinds that I'd like to control using your solution. The blinds are currently controlled via VarioCom Slide remote (with 6 device banks), with the blinds assigned to bank 1 & …
-
### The problem
**Background**
Recently I started using the Motionblinds Bluetooth integration with roller blinds and CMD-03 motor. The initial setup of the CMD-03 motor was done with the Motionblin…
-
What do you think about also providing a pre-configured Zigbee router firmware image for the IKEA Trådfri ICC-A-1 Module?
Checkout Ikea Tradfri Zigbee Repeater Umbau project with Zigbee router fir…
Hedda updated
3 years ago
-
### What happened?
While I've never been facing any issues for more than a year with the Sonoff Dongle-e + ezsp driver, I've tried to change the driver to ember, but nothing is working (tried multipl…
-
### Hardware
ESP32 WT32-ETH01
### Firmware version
v2.3.3
### Application version
v2.3.3
### What happened? What did you expect to happen?
The board with the ETS works great,
I have 2 of them …