-
This was posted here as a bug: https://github.com/Aircoookie/WLED/issues/3927
I see it was marked closed but I am uncertain why? It maybe should have been a feature request?
Just like Wifi, Ethern…
-
In the paper it is mentioned that the Ethernet headers, IP headers and port numbers are removed. But in generating the pre-training data(In get_burst_feature() function) I see that only first 64 bytes…
-
Hi, First of all, thanks a lot for these wonderful kernel and builds.
**Device**: NanoPi R6C
**Issue**: This device has 2 ethernet ports(1G and 2.5G), upon connecting to any router using the 1G po…
-
STR:
- Install Ubuntu Server 24.04 and configure networking
- `$ sudo snap install --edge webthings-gateway`
- `$ snap connect webthings-gateway:system-observe`
- `$ sudo snap connect webthings-ga…
-
Hi, in my residential installation I've installed a Sungrow SH3.0RS which I do not know if it's officially supported with this project (the readme mentions SH3.RS, SH3.6RS and i guess mine is the firs…
-
### Enhancement summary
We are trying to adopt arista AVD version v5.0.0, and finding below validation errors.
```
ERROR! [MBH-CAMP0S]: 'Validation Error: servers': Invalid type 'dict'. Expected …
-
I recently acquired two T-Halow modules and configured IP addresses through the Ethernet bridge. However, when I disconnect the Ethernet cable, they lose connectivity. This is expected, but can we co…
-
This is the command "sudo /usr/local/ndpi/bin/ndpiReader -i ens192 -k output.json -K json -m 300" I have run on my Ubuntu machine and the traffic statistics are:
Traffic statistics:
Ethernet…
-
### The problem
There is an ESP32 with an Ethernet module W5500.
If you set to work with manual_ip, then the web interface will load, if you do not specify manual_ip, i.e. We switch the module to t…
-
What is the recommended way to setup a wifi or ethernet connection after successful install? I also ran into this issue with v22 server install. If netplan in `/etc/netplan` what is the recommended fi…