-
Where to connect Ender 3 filament runout sensor?
-
### Description
When printing after a 30 minutes I get filament runout error and pausing print. Even there is no filament runout.
### Steps to reproduce
I push Icon resume and than printing…
Blisk updated
1 month ago
-
Hi, I hade few issues in just 2 days (frustrating) when I had to disassemble hotend, after I ran out of filament on the spool. Now it works like this:
1. Filament runs out - good
2. First sensor is …
-
Tried your filament sensor code and klipper chokes on:
{% set _dummy = filament_sensor.update({params.SENSOR|string: params.ENABLE|int}) %}
stating that there is no .update in jinja. Any though…
-
Today, my QIDI Q1 Pro is consistently reporting the filament sensor as "Off" even though there is filament present. I used the commands ENABLE_FILAMENT_WIDTH_LOG and QUERY_RAW_FILAMENT_WIDTH to check …
-
This is just to track and not forget for the next version to add this: https://github.com/bigtreetech/smart-filament-detection-module
```
[filament_switch_sensor switch_sensor]
switch_pin: gpio…
-
### Bug Description
Marlin 2.0 filament runout sensor error
filament is working and status is correct when using pronterface. Also i measured voltage with and without filament and values are …
-
The Creality K1 seems to have no spare port for the motion detection.
Is there a way to use the sensor with this printer?
Or in general:
Is there a way to use the sensor if only a "normal" filament…
-
I'm running the BTT smart Sensor v2 on a Voron 2.4 with klipper. When I print things seem to work correctly until some point where the switch sensor gets triggered. When I heat the hotend and extrude,…
-
### See comments for delayed filament runout to reduce waste (XL)
Original issue:
## Continue printing until infill on filament runout sensor trigger
**Printer type** - MINI+
**Optional upgra…