-
I am looking for a C++ FIRMATA client Code for the Windows 10 client. I am not sure if I am missing something or just one needs to be proposed.
-
Hi,
if I use this code on StandardFirmataPlus, the firmata works on the begin but then it stop when I send Firmata.digitalwrite from my client program.
Code into StandardFirmataPlus:
void …
-
Im using Perl-firmata as Server, and Firmata sketch as client with ethernet to connect several boards.
I have to hardcode in each board these values:
```
byte mac[] = {
0xDE, 0x55, 0x5E, 0xE5,…
-
I started with RCSwitchFirmata, could not get it work. I think I should test ConfigurableFirmata first. So I upload ConfigurableFirmata to my UNO, and use a client code with firmata lib like below:
…
-
Hi,
I am trying to get the example code shown in the README.md to work.
If I run this code, the listener is never invoked. I am getting the same results with OSX and Linux
clients. Any help would b…
-
It would be useful if a firmata host could enumerate attached i2c devices on a firmata client.
A full scanner is not required, just the ability to detect the error from a wire.endtransmission .
cf i…
-
```
Hi,
I can't communicate with my Arduino (Duemilanove, ATmega168) with
Firmata under Linux (Arch Linux 64 bit).
I tested both "stock" Firmata that comes with Arduino IDE and
Firmata-2.1beta7.zip d…
-
Testing my Lazarus client for firmata I found missing informatión when firmata reports encoder pin capability.
It only shows pin2 and pin3 and from my reseach all pins are encoder capable so report…
-
```
1. Uploaded Firmata to my Arduino Mega board
2. Configured serproxy with the serial port and baud rate. Says it's waiting
for clients
3. Loaded the monitor, which connects with Serproxy. Gets stu…
-
# Standard format client
I browsed through code and could be not certain to figure if the project has a client for dealing with Standard Firmata firmware. Does it have and I just didn't found it?