-
Hello dev team, I'd like to start by saying Bruce is my fav firmware for my cardputer. Great job.
While using your firmware for productivity purposes, I do have a few ideas and requests which I figur…
edeot updated
4 weeks ago
-
In the `firmware-cmake` branch, on my minimal windows 11 + MSYS + MinGW64 setup, it will build fine if I use cmake to generate Makefiles:
```
cd firmware
cmake -B build -G"Unix Makefiles"
cmake …
-
As brought up by @robertbrada and discussed on Slack. Suite and firmware currently shows different QR code although the content is the same (or maybe different case?). Let's:
1) Investigate whether…
-
Hi all,
I have been using the RFSoC 4x2 to generate I and Q inputs for an external IQ mixer using DAC_A and DAC_B on the board. I have written a few calibration scripts to compensate for the freque…
-
**Actual Behaviour**
The frequency measurements of LA3 and LA4 are not correct in the Multimeter.
**Expected Behaviour**
The Multimeter always displays the correct value for the frequency on …
-
Is building the firmware on powershell supposed to work? I get the error that template is not defined on all examples:
`go run .\cmd\zigbee\main.go --config .\examples\factory_reset\zigbee.yaml fi…
-
Hello,
I'm currently using SNZB-04 dry contact sensor to report magnetic pulses to Z2M and HASS. However my sensor is at far end of the mesh and sometimes the messages get lost. I was hoping to us…
-
Hi, we're working with the following supermicro BMC output:
```
$ sudo ipmitool bmc info
Device ID : 32
Device Revision : 1
Firmware Revision : 3.10
IPMI Ve…
-
**Actual Behaviour**
The Logic Analyzer displays results for all 4 channels, even though only LA1 is physically connected to a source.
**Expected Behaviour**
The Logic Analyzer only shows a r…
-
## Background
They are cases when you need to type one-handed without moving your hand to the other split but be able to press the keys on it. That's especially relevant when the splits are far a…