-
The following output shows an example of a chip misbehaving and not training up causing tt-flash to hang. It's currently not obvious which board/chip is problematic.
```
ansible@e14cs04:~$ tt-flas…
-
When using espflash 3.1.1 on the P4 dev board, it fails to detect the chip:
```
$ espflash board-info
[2024-09-12T15:32:39Z INFO ] Serial port: '/dev/ttyUSB0'
[2024-09-12T15:32:39Z INFO ] Connec…
-
EVE3 can read/write SPI flash chips, commonly used to store things like fonts, audio files, etc.
- [x] low-level flash i/o support
- [ ] support for displaying bitmaps from flash
-
I was successfully able to flash my GalagoPro 3 C using Raspberry Pi. However, I had 5 hours of struggling trying to flash the built rom. spipi.sh kept telling me, chip not found. After digging and go…
-
Esptool already supports writing to flash chips larger than 16 MB. Octal and quad flashes had to been implemented differently. This is probably relevant for ESP32-S3 only for now. I assume it will be …
-
From reading #20 it seems I could use this on the Aliexpress nRF51822 beacon chips by simply taking the existing firmware.bin and replacing the string with the advertisement key.
Could this process…
-
It seems like the target yaml files that correspond to TrustZone enabled chips contain flashing algorithms for both secure world and non-secure world. But it seems like there is no support in probe-rs…
-
Hello,
I am in the process of deploying the HelloWorld example onto my MAX78000FTHR board. I am using the OpenOCD aarch64 version since the i386 version does not work, even with Rosetta 2 emulation,…
-
Hello world :-)
Would it be possible to:
* add support for flashing BL606(P) chips?
* add example `helloworld_bl606.bin`bin to try out flashing.
Thank you :-)
-
I have a few door sensors that have XR3 chips in them. I have been struggling to flash these manually. The few documented flashing guides I have found are a little confusing to me. I am pretty sure I'…