-
× Building wheel for ft4222 (pyproject.toml) did not run successfully.
│ exit code: 1
╰─> [28 lines of output]
running bdist_wheel
running build
running build_py
cr…
-
No change in SS0 when changing between Cpol.IDLE_LOW and Cpol.IDLE_HIGH. Both show SS0 idling high.
Using:
```
#initiate ft4222 channel
spiA = ft4222.openByDescription('FT4222 A')
#set channe…
-
There is an issue loading libft4222.dll: I get an error `unable to load shared library!`
I am using windows 11.
Tried updating lib-ft4222.dll manually by downloading latest dll from ftdi page. It s…
-
Hi,
I use FT4222 with SPI and know I want to use also GPIO3 as Interrupt. So first I tried both separately, it works correctly but after if I use both in a same code, it fail at nivel of **x = mraa…
GuzMp updated
7 years ago
-
Do you have the code for the low power example?
-
Apparently, most of our users in this library are using Linux distributions and not Windows IoT.
Should we continue to support Windows IoT for the dotnet IoT libraries or would it be better to simp…
-
**Describe the bug**
At the moment, it isnt clear from the README what versions of Raspberry PI are supported. The driver files indicate Pi3 and above but it isn't clear.
It looks like on PI2, it …
-
When running the sample found at https://github.com/dotnet/iot/blob/2cc943168d4b20339a4c3046a5c8a952b273afcb/src/devices/Mfrc522/samples/Program.cs
using the below shown command, no result was show…
-
I am using libgpiod 1.6.2 on a RPi ~3B~ 4B with Raspbian Bullseye. I have implemented an interrupt monitor strictly following [this](https://github.com/brgl/libgpiod/blob/v1.6.x/bindings/cxx/examples/…
-
**Describe the bug**
When I execute the Sample code, I get an error message like the following.
Unhandled exception. System.ArgumentException: No PWM device exists for PWM chip at index 0. (Param…