-
**What happened**:
**What you expected to happen**:
**How to reproduce it (as minimally and precisely as possible)**:
**Anything else we need to know?**:
**Environment**:
- Kubernetes v…
-
Before getting to the timers, I would say that this started with a question from Ralim regarding the optimum frequency of the TIM3 CH1 output against the AC coupling between the TIM3 CH1 output (route…
-
**Describe the bug**
4K videos played back with go-vod from within the memories app are stuttering to the point of being unwatchable. HD videos work, but they are not completely fluent, either.
Play…
-
### Describe the bug
Currently burp runs in a FHSEnv. This is good enough to get it opening and browsing the web in software mode. But features that rely on additional libraries such as hardware acce…
-
- Plug in the uMWC into an EV hardware simulator
- Do a basic charging session (Pulse Width Modulation/Control Pilot/Proximity Pilot)
- Figure out and document how to debug when things go wrong
-
The next GoXLR firmware release is going to add two new output channels for the full sized device, labeled a 'Stream Mix 2'. Outside of general usage, there's no way to determine whether these channel…
-
### Package
Fooocus
### When did the issue occur?
Running the Package
### What GPU / hardware type are you using?
gtx 970
### What happened?
I can't find the answer anywhere on the internet.
…
-
I have two LYWSD03MMC sensors HW rev 1.4.
I appreciate HA questions go elsehwere but my question here is about the sensors.
Why does FW 47 and FW 48 report different sensors for the same Hardwar…
-
### Version
EX-turntable
### Issue description
For the 2 relais module ,on my one there is not six pins but seven : JD-VCC,VCC,GND and seperatly : GND,IN1,IN2,VCC my question is,how do I go from t…
-
Your comment about RPi5 not supporting v4l2 hardware encoding and suggest there is a solution for software encoding but stop short of going into any detail how this might be done. Can you report this…