-
Hi Mike,
Firstly, thanks for an excellent MicroPython library for the rotary encoder. So many resources use Circuit Python or Arduino only, so it's great to come across this!
My issue is that I'm…
-
At the moment, SERVMOD is controlled using FPGA GPIOs
This means I2C resources of the DIOT crate wouldn't be available from USB I2C.
This would make crate configuration identification impossible wit…
-
when using low profile ram or gpio extender and io board system freezes when both are installed together.
-
I'd love to be able to run a full python IDE while creating my projects. With the [GPIO extender](https://bennuttall.com/raspberry-pi-zero-gpio-expander/) tool, I can do just that! However, I don't th…
Kisty updated
5 years ago
-
I received a HATDrive! Top and a HATDrive! Bottom 3 days ago and the work great!
Just assebleing the HATDrive! Top with the included 28-pin header extender didn't work:
Drive was heating up incr…
-
Operating system: Debian GNU/Linux 12 (bookworm)
Python version: 3.11.2
Pi model: Raspberry Pi 4 Model B Rev 1.4
GPIO Zero version: 2.0
Pin factory used: LGPIOFactory
I have connected GPIO ext…
-
# Please answer the following:
**FPP Version and Hardware**:
FPP 6.3 running on RPI Zero 2 W and RPI 4
**Describe the bug and Steps to reproduce**:
I'm using the pca9554A gpio extender chip …
-
I'm noticing that a lot of sensors are being added, with Kconfig symbols like `CONFIG_LM73C`, which doesn't say whether an "lm73" is a sensor, or a flash storage device, or a GPIO extender, or whateve…
-
Hello, @LilyGO @lewisxhe
I have the NA version of the SIM7600 and it doesn't seem to return the GPS coordinates. I have tried with the AllFunctions.io (AF) program as well as just issuing the follo…
-
Firt of all, great piece of software for the LPC series. It works beautifully with LPC824 using buttons for Reset and Boot0. Thanks for writing it!
Doing:
$ lpc21isp build/i2c_isr.hex -control /…