-
## Overview
- Integrate the [Seeed Studio Grove Pi HAT](https://www.seeedstudio.com/Grove-Base-Hat-for-Raspberry-Pi.html) with the new Raspberry Pi 5 to enhance IoT projects.
- Enable communication(di…
-
## Issue Summary
A person with a health sensor set to ON and DEAD attached to a TTV
TTV is cavity implanted in chest
kill person, TTV does not go off
if you take the TTV out via surgery …
-
## Overview
- We encourage you to share your thoughts with us by leaving comments below.
- Whether you have a "solution-based" prototype, a deployable resolution, or just an interesting project idea,…
-
Any chance for a wrapper for the Grove magnetic switch to be added to the modular Sensors library?
-
+ [ ] LEDblink
+ [ ] button
+ [ ] i2c-ADT7410
+ [ ] i2c-PAJ7620-Gesture
+ [ ] i2c-PCA9685
+ [ ] i2c-S11059
+ [ ] i2c-SRF02
+ [ ] i2c-VEML6070
+ [ ] i2c-grove-accelerometer
+ [ ] i…
-
Hello Microchip community,
Hardware: AVR-IoT-Cellular mini, Water level sensors (once Grove seeed connected to I2C, once Endress+Hauser Liquipoint connected to GPIO)
Software: avr-iot-cellular-ard…
-
It seems that mraa and upm libraries and not maintained anymore. So you cannot use mraa and upm related Grove modules. FIX THIS BLOODY ISSUE AND DO NOT CLOSE IT AGAIN UNTIL IT IS FIXED.
-
Hi
I would like to be able to control a LEGO Boost (or LEGO wedo/Spike) Hub with Micro:bit.
The hub connect via bluetooth Low Energy (BLE).
Makecode for Micro:bit allows to send/receive messages th…
-
Hi, @gloveboxes I followed your steps but debugging the code my SHT31 is not being initialized/Open.
after initializing the GroveShield with `void* sht31 = GroveTempHumiSHT31_Open(i2cFd);` the code i…
-
[ADC2 channel cannot be used when WiFi is in use](https://desire.giesecke.tk/index.php/2018/01/30/adc2-channel-cannot-be-used-when-wifi-is-in-use/).
M5Camera uses the pins which cause `analogRead()` …