-
Seguimos por aqui las correcciones. Cuando hagas push por favor escribi en este issue, asi me llega la notificacion.
-
I'd like to use this with a HC-SR501 Motion Sensor built-in (connected to the Pi 0).Would you consider adding support for that? Both in the software as well as an edited version of the hardware enclos…
-
If one where to create a graphical/textbased menu system UI in C# using .NET IoT device bindings for input (gpio, buttons, rotary encoders) and displays (1/2/4 line textmode or small graphical display…
-
Hi!
I was wondering if I can use an AM312 instead of the HC-SR501 for motion detection.
And, the issue:
I am using the ESP32 with a DHT22 and a Motion Sensor. In the serial monitor, it keeps loop…
-
**Describe the bug**
The value key definitions for temperature (BME, HTU, AHT) and presence (HCSR501 sensor) do not align with the keys that these sensors use. This causes the mqttDiscovery to fail…
-
Headline kinda says it all, but....
Can I use the ESP32-Cam (OV2640) Board with OMG?
Direct link to AliExpress (example, no affiliate): https://www.aliexpress.com/item/33027303390.html?spm=a2g0o…
-
Before submitting a problem please check the troubleshooting section
https://docs.openmqttgateway.com/upload/troubleshoot.html
**Describe the bug**
I hava geniune Arduino Uno and Arduino IDE tell…
-
Hi,
im trying the release 0.9.3 but after i set the wifi info on the WEB interface, on serial i can see a restart with:
**Trigger button Pressed
Button Held
Erasing ESP Config, restarting**
…
-
First and foremost this is great so thank you, I've been using it on a nodemcu as just a IR, RF receiver and Sender for over a year, but decided I wanted some extras like PIR and a temperature senso…
-
Is it possible to receive KaKu on the Sonoff RF Bridge (v2)? I tried to enable `ZgatewayRF2` but this doesn't seem to do much
I'm currently testing with the APC3-1500R and APC3-2300R but both don'…