-
Hi Mike.
The CS1237 plays in the field of the HX711, but is told to be less noisy. My test did not show a huge difference, but that may be a problem of the test set-up. It's more flexible than the HX…
-
This component should provide easy access to the strain sensor readouts. Support already exists in the esp-idf-lib so this should be a simple wrapper.
This component should also have a means to calib…
-
Dear Mr. Robertson,
I was unlucky today when following your instructions. All your examples and calibration.py use ' from HX711 import * '.
HX711 is nowhere to be found by Python 3.9.2 on my RPi4B…
-
I wrote a test example for your library: https://github.com/pronvis/drawer-robot/blob/master/crates/companion/src/bin/hx711_spi_read.rs
And it reads absolutely noise:
```
└─ hx711_spi_read::app::hx…
-
During calibration motor won't start rotate without little push. It often fails whole calibration.
```Starting calibration, please DO NOT TOUCH MOTOR until complete!
LOG: HX711 reading: 1073822
L…
-
Hello are you able to add a Temp compensation for HX711 Plugin?
Problem is that with changes in room temperature my scale shows different values. It would be nice to have a solution for it like Com…
-
If the read is a busy loop, maybe that's wasting energy and I instead can sleep until it's ready.
-
Hi guys,
Is it possible to write a new driver for HX711 weight cells in Gobot?. Can i use some other device driver supported by Gobot as example?. And if it is possible, under which platforms (rasp…
-
Hi,
I believe it is not ideal to indicate that the HX711 should be connected to 5V. That is totally fine with an Arduino, but probably unsafe with the RPi.
I am not sure what exactly might happen,…
-
The two mechanisms are similar conceptually and mainly differ syntactically. The following command can illustrate the changes required:
```console
$ git diff 38730032..e9571705 -- glasgow/applet/i…