-
I note that there is a closed issue regarding this topic (https://github.com/smillier/HydraLINCAN/issues/3) that did not appear to have a fulfilled resolution.
I too am interested whether there are…
-
Hello beautiful people.
I work for a big ECAD software house, writing articles.
I would like to make a couple of articles improving the bus pirate V4 hardware.
Which features / improvements / b…
-
I want to add support for the `dp83848` Ethernet module from Texas Instruments, but after searching through the forum and the docs - I found no description of what is necessary to accomplish that.
…
-
I am encountering an issue with the Hydrabus device when trying to use UART bridge mode. Specifically, I am unable to connect to the device using WebSerial via a browser. The connection attempt fails …
-
Hi bvernoux
Can you add firmware later x8 and x16 nand support (I read about nand support somewhere in web for this board)? And also add 1-2-3 wire support would be good. I noob but trying MN101EF31G …
-
hello, would it be possible to add the k-line protocol? THANKS
-
It would be nice to make the BSP suitable for all CH56x
boards (like the official development board),
and enable the Hydrabus-specific parts with a compiler define.
-
Hi Team, I recently ordered a hydrabus for my hobby project and trying to communicate with my PN532 module via I2C. Then it turns out hydrabus doesn't support clock stretching in I2C, hence when PN532…
-
I bought a HydraBus a few days ago and started to play with it:
```
> show system
HydraFW (HydraBus) v0.9-beta-115-ge463bc7 2020-01-29
sysTime: 0x046b48aa.
cyclecounter: 0x00809116 cycles.
cyc…
-
Do you take orders for prebuilt boards? I see that they were available at some point. If so how where can I get one vs building myself if possible.