-
I'm on a RP2040 using eeprom_target to emulate a 4KB EEPROM with 4KB addressing. When the Linux host reads my emulated EEPROM using the 24c32 driver in 128 byte chunks, it issues an 2byte address wri…
-
E (1086) i2c: CONFLICT! driver_ng is not allowed to be used with this old driver
void rtsp(void *arg)
{
esp_log_level_set("*", ESP_LOG_INFO);
esp_log_level_set("AUDIO_ELEMENT", ESP_LOG_E…
-
Whilst writing to an I2C EEPROM it's necessary to write eeprom memory address followed by the data to write without a STOP between the address and the data. A typical write function would accept a mem…
-
After flashing your jetson-image using **`flash.sh`** , it successfully boots on the first attempt. However, subsequent attempts to boot fail. The initial boot is successful, but subsequent boots resu…
-
I have a few Pi's + PiSugar's and all work fine with Dietpi, except the new Bullseye version - the PiSugar is very sluggish to respond to commands.
The settings are duplicated with the working one…
-
### Answers checklist.
- [X] I have read the documentation [ESP-IDF Programming Guide](https://docs.espressif.com/projects/esp-idf/en/latest/) and the issue is not addressed there.
- [X] I have updat…
sfzhi updated
2 months ago
-
SCHEMA 100%
CVPCB 100%
PCB 100%
Ready for production
f4deb updated
9 years ago
-
Hello! I have a question regarding the "DECK_INFO: Warning! No driver found for deck." issue.
I am using Crazyflie 2.1, Flow Deck v2, Crazyradio, and Lighthouse Positioning Deck. When using the cra…
-
```
The recommended I2C address table for the module EEPROMS is wrong.
It says that the UART is on the left bus, whereas it is on the RIGHT.
It says that the Ethernet/RTC is on the right bus but it …
-
Would it be possible to implement serial eeprom read/write over i2c? This would be very useful for reverse engineering. I have constructed a 3.3v to 5v bridge using an ISO1541 ic and can access data o…