-
Hi Tom,
I tried to initialize PCM5122 with 3-wire I2S and I did what was suggested by start up the I2S source for about 1000ms to let the DAC exit the default reset state and then calling the confi…
-
Hi,
I have WS32-ETH01 board im trying to use it as VoiceAssistant throught PCM5102 DAC
This board support i2s audio?
Its working on esp32-wroom but not o eth01 module, the leds on eth port turn o…
-
The ESP32 S3 does not have a built-in DAC, but it has been identified as an ESP32 device and cannot use PWM analog output. Is there any way to solve the problem of using ESP32S3 normally without exter…
-
**Describe the problem you have/What new integration you would like**
Please look at adding standardized volume control configuration for external DACs with integrated [PGA (Programmable Gain…
Hedda updated
2 weeks ago
-
### The problem
I am trying to use the speaker component to play() raw audio. I have audio encoded as signed (little endian) 16-bit, 16kHz mono and then converted to hex using `xxd`. The audio sample…
esand updated
1 month ago
-
I have the Luckfox Pico Max and i want to connect an i2s DAC to it, is it possible to change the pins of an interface for example the SPI to i2s using the device tree?
-
I think it would be a good idea to switch from the internal dac to i2s, this will improve the sound quality and remove noise on the internal dac
-
Hi, does LUCKFOX Pico Pro or Max support I2S protocol. Simply, can I talk to a audio ADC or DAC (like PCM5102) with my Luckfox Max?
Can any of the current GPIO pins be used as I2S pins?
-
Howdy!
I would like to use the DAC of the ESP32 in DMA mode. The dac.rs itself only supports direct writing to it but I guess that is fine for some use cases. According to the documentation in the …
Slamy updated
4 months ago
-
While attempting to compile and build the Galagino package for a ESP32-2432S028R (aka, CYD or "Cheap Yellow Display") using the Arduino IDE under Windows 10, with the 2.0.14 version of the esp32 board…