-
when the sun is setting the reading from the illuminance sensor progressively goes down until it gets around a reading of 65 then starts going back up (800 )and behave erratically until i get a rea…
-
### What happened?
Logs from journalctl:
```
Jan 18 10:40:01 raspberrypi npm[1744490]: Zigbee2MQTT:info 2024-01-18 10:40:01: MQTT publish: topic 'zigbee2mqtt/vallhorn', payload '{"battery":100,"…
-
All radar sensor data just stops populating altogether in HA. In the Esphome logs too I cannot see the sensor data peing updated.
Tried this on 2024.6.6, 2024.7.0 ESPhome. Works fine after a firmware…
-
### Question
I am trying to setup a battery powered zigbee device/sensor with deep sleep to ensure long battery life. However I am struggling to send a new value to the corrdinator after the device w…
-
Since the sensor is a calculated value, would it be possible to provide the forecast of illuminance in the next 12 hours, if the forecast data is provided?
For example, the Accuweather API (not th…
-
**Just discovered this project and love the discovery feature.**
It would be awesome if you could support Illuminance, as I'm using the Flora plant sensor and it is possible because home assistant …
-
Hi,
I just updated HA to 2024.7.4 and this integration to 3.4.7 however after a reboot I am getting an error stating:
Lux - Upstairs Hall uses an unknown action
The automation "Lux - Upstairs Hall"…
-
### What happened?
Past 2 days I installed 5 Bosch RFDL-ZB-MS on Z2M, moving them from Deconz.
Problem: Z2M does not sets Tamper alert back to FALSE after is been TRUE. I have let them sit over…
-
Hello,
I am on my FW16 and I installed the service via paru from AUR. It was installed correctly, my config was edited but it does not do anything. My brightness stays at the same level. However, the…
-
When the ZSE11-800LR is in direct sunlight it is reporting negative values instead of maxing out at 32767. FW: 2.00, HW: 2, Driver: 1.2.2
![Zooz Configs](https://github.com/user-attachments/assets/…