-
# What Does This Component Do?
The INA219 is an I2C Power Monitor that is currently used in the PROVES Kit to monitor the total power consumption of the system and also monitor how much power is com…
-
Add INA219
-
### The problem
I try to use an ina219 with my Pico W and ESPHome.
It wired to GP6 and GP7 which is the I2C1 on the Pico W.
When I configure this in yaml, it stops booting correctly.
No usable l…
z-eh updated
45 minutes ago
-
Can you explicit how to find the i2c address ?
I installed correctly HassOS I2C Configurator
last lines are
```
/dev/i2c-1
/dev/i2c-0 /dev/i2c-1 /dev/i2c-10 /dev/i2c-22
Found i2c access! Nothin…
-
Venus OS: V3.51
Pi4
Sensor: ESP32 and INA219 for testing purposes
I followed the install sequence as written. The service is running ok, as it seems.
My sensor is publishing mtqq to Venus OS b…
-
### Category
Other
### Hardware
Other
### Firmware Version
2.5.7.f77c87d
### Description
RP2040-LORA-HF device is ignoring request to set INA219 as main battery device.
Continuously reports as…
-
Hello.
On my device ([CM4-POE-UPS-BASE](https://www.waveshare.com/wiki/CM4-POE-UPS-BASE)) the the INA219 is available on i2c-10 0x43 and the integration does not detect any sensor.
How can I set t…
-
After instalation:
```
Invalid config
The following integrations and platforms could not be set up:
[ina219_ups_hat](https://github.com/odya/hass-ina219-ups-hat) ([Show logs](http://192.168.0.10…
-
-
can you provide example usage for ina219 with micropython