-
Hello,
just set up my first selfmade cul with the latest(1.26.0.4) aculfw on an arduino nano v3.0.
For some reason the device alyways entered some strange mode when sending commands to my inter …
-
- [x] Arduino Motor Shield PWM Test
- [x] Ultrasonic Sensor(HR-SC04) Test
- [x] Quadrature Encoder Test
- [ ] MPU9250 IMU test
- [ ] Nucleo Raspberry-Pi inter-communication Test
- [ ] R…
-
I suspect I am using it the wrong way, so I'm not sure whether it is proper that I write here. However, I could not make the inter_byte_timeout work, and I could not find help in other places.
I hav…
velle updated
4 years ago
-
Would it be possible to use the MPU6050 DMP code using a Raspberry Pi?
So far the code is only available for Arduino, any plans to make a port for using it with a raspberry pi using only the GPIO …
-
```
What steps will reproduce the problem?
1.
Run it with any baud rate above 19200. Use it with > 8 coil or digital
registers.
2.
Inter-message timing calculation is not right for all baud rates, r…
-
```
What steps will reproduce the problem?
1.
Run it with any baud rate above 19200. Use it with > 8 coil or digital
registers.
2.
Inter-message timing calculation is not right for all baud rates, r…
-
```
What steps will reproduce the problem?
1.
Run it with any baud rate above 19200. Use it with > 8 coil or digital
registers.
2.
Inter-message timing calculation is not right for all baud rates, r…
-
```
What steps will reproduce the problem?
1.
Run it with any baud rate above 19200. Use it with > 8 coil or digital
registers.
2.
Inter-message timing calculation is not right for all baud rates, r…
-
```
What steps will reproduce the problem?
1.
Run it with any baud rate above 19200. Use it with > 8 coil or digital
registers.
2.
Inter-message timing calculation is not right for all baud rates, r…
-
```
What steps will reproduce the problem?
1.
Run it with any baud rate above 19200. Use it with > 8 coil or digital
registers.
2.
Inter-message timing calculation is not right for all baud rates, r…