-
The PCF8563_RTC will not compile in the arduino IDE,
Around line 270 in the pcf8563.cpp the following code exists.
void PCF8563Class::initialize (void)
{
INTERNAL_EEPROM_PORT.begin();
…
-
Hi!
IAW5AM has firmware stored in flash, data handled by this utility I think, and an eeprom where ECU store Immobilizer data and troubles snapshots. There are a way to read an write this eeprom usi…
-
-
The output power of the inverter can be set via the openDTU with two different parameters: "permanent" (persistent) and "non-permanent" (non-persistent).
There is only one parameter, is it permanent …
-
Using a handful of these Hanshow tags and the alpha TLSR firmware, I've discovered the firmware works perfectly on tags with serials beginning with 3.
However while I can flash tags with serials be…
-
### Description
Ender 3 - Skr mini e3 v2: I can not save to EEPROM from marlin or terminal. When I flash new firmware (bugfix 30/7-20) I do M502, M500 and get: echo:Error writing to EEPROM!
echo:E…
-
Different EEPROM files are required to achieve best performance depending on the power amplifier (PA) and low noise amplifier (LNA) type which, as far as I understand, can be ePAeLNA, iPAiLNA, iPAeLN…
-
#### Description
When cable is SFP/SFP+/SFP28, most key names are not consistent between "show interfaces transceiver eeprom -d" and "sudo sfputil show eeprom -d". For branch 202205, the outputs …
-
## Introduction
For years zephyr has been using the flash_area API to work with images and storage solutions. This API has limited the development of zephyr because:
a. It is limited to flash, t…
-
In my tests, the following code (changed a little for a minimal test case):
```c
typedef unsigned char uint8_t;
typedef struct {
uint8_t port;
uint8_t bits;
} ws_eeprom_handle_t;
ws_eep…