-
Would it be an idea to rewrite the code to make use of ESP-Now for incoming data?
(And of course, let the iSpindel itself also push out the status via ESP-Now)
- This has multiple benefits, no nee…
-
Bonjour,
Ne faut-il pas rentrer la configuration du tilt du ispindel.
Il me semble que les données remontées sont différentes de celles relevées sur littlebock.
Je suis sur le firmware 6.2.0
M…
-
Is it possible to add fermentation logic to change the target temperature when specific gravity provided by iSpindel is reached?
-
Hi Vito. Still loving my BPL a lot! I have a question / suggestion. In the iSpindel section on the main (graph) page, all the iSpindel values are displayed except the temp. I find it usefull to monito…
-
Hi
I installed firmware 3.4 in my BPL D1 mini, it works fine but does not connect with Ispindel.
i have setting for Ispindel support but the Ispindel window does not appear.
In the Ide Arduino ser…
-
I just finished building an iSpindel and linking it up my brewpiless setup. The gravity reading seems to coming through fine but the temperature is off by almost 100F. The temperature reads correct in…
-
I have a clean new installation of Raspbian Stretch and Craftbeerpi3.
After successfully installing the iSpindel plug-in and subsequent reset, I can configure Craftbeerpi3 with a new sensor for tempe…
-
It can be flashed from esphome, but maybe adding it to catalog will be helpful to have everything in one place.
https://github.com/alsFC/esphome-iSpindel
-
The readings from iSpindel and Tiltbridge go directly into the brewpi.py script whereas Tilt has a class which performs a smoothing/averaging. See if we can get a class together to hold/track these v…
-
First off, thanks for all of hard work you guys have done over the past 15 months(ish). Given that this server has the ability to capture both picoferm and iSpindel data, I was wondering if this data …