-
初始化如下:
`...`
`sfud_init();`
`fal_init();`
`fdb_tsdb_init(&s_chargedb, "chargedb", NOR_FLASH_PART1_NAME, get_time, 512, NULL);`
`...`
每次上电都会重新格式化扇区,并且分区表的起始地址不正确。
日志如下:
[SFUD] (../3rdparty/…
-
As same as `EN4B` / `EX4B` , Read Status (1,2,3) , Read JEDEC ID, Read SFDP commands have fixe values in their command information entries. It is better to split out those entries into new CSRs like `…
-
你好,你的工具设计很不错,我尝试了下,修改def为winbod W25Q64BV,运行后发现在
“sfud_erase”中执行write enable报错,但我用其它驱动读写都没问题,说明板子是可以write enable的,看你的代码中有lock spi 然后unlock spi这个动作,不太明白为什么需要,也不清楚为什么Status Register的WEL位没有置1,请问可以帮我看看么,谢…
-
Hi,
I would like to implement littlefs in a project , but i have a limitation : various flash could be soldered on the hardware , and some don't have subsector command (or at least only half sector…
-
### Describe the bug
- After booting my device i get a kernel dump
- i get "enabling reset hack; may not recover from unexpected reboots" but 4-Byte opcodes are supported
see "Steps to reproduce"…
-
from flashrom:
```
flashrom v1.2 on Linux 4.19.72-gentoo-9e (x86_64)
flashrom is free software, get the source code at https://flashrom.org
flashrom was built with libpci 3.5.6, GCC 9.3.0, lit…
-
**Is your enhancement proposal related to a problem? Please describe.**
SFDP headers are read up to static allocated amount (spi_nor.c: 3, stm32_qspi.c: 3, stm32_ospi.c: 3) It would be possible to ma…
-
@pan-
I'm not sure what's going on here, this repo works when I build it with the mbed-os-6.9.0 tag. But when I build it with the current master (84e5f1e03eed2227d91937c38ab862297ee9c2d6) it results…
-
Probably not exiting DPD properly after JEDEC
check drivers/flash/spi_nor.c: spi_nor_process_sfdp()
-
Hi, from what I could see, there is no support for the P25Q40H and P25D21H found in some external SATA III to USB 3.0 enclosures. I would like to request its support in Flashrom if at all possible.
…