-
I know, this is primarily a feature request for the Pinscape Firmware, and only indirectly a feature request for the PinscapeConfigTool.
Recently, some measurements were carried out in the communit…
-
Hi,
I updated to the new FW [Pinscape_Controller_KL25Z_20240818.bin]
After that DOF don't work anymore. In the log are USB errors:
Pinscape Controller USB error reading from device: The supplied us…
-
https://github.com/EmbedSoftCo/FRDM-KL25Z_code/blob/6368ade24ad289713a73f94eaeb1093a873f0c44/EmbeddedSoftMainProgram/gps/gps.c#L11C13-L11C19
-
The dereference of `ptrSeed` in line 603 of `Hardware/Kinetis/kinetis.c` causes a hard fault when built for the FRDM_KL25Z (which does not have RNG hardware), because `ptrSeed` is 0.
In `Hardware/S…
-
I have a few KL25Z FRDM boards laying around and think it would be an interesting board to add as it has a Cortex M0+ rather than an M3/M4. The FRDM board from freescale can be bought for $12.95 and …
-
I found another alignment problem, this time i was experimenting with the FRDM-KL25z board, I experienced a hardfault whithin the bss zero loop (using a modified startup assembly from freescale with l…
-
The current method is all of the designated output pins are available - you could call this the "KL25Z interface". Then the user adds I/O chips such as the TLC5940. This creates conflicts that then ha…
-
I am using a modified FRDM-KL25Z board to debug a KL27Z design. The debugger is flaky and works sometimes, but mostly doesn't work. Using the debug log in the AppData I can see that it is talking to…
-
## Descrption
My code was running fine until I added the timer object, then a HardFault issue is always shown
## Expected to find...
Timer running in board correctly
## Found
![image](https://u…
-
Study the ADC channels of KL25z and its possible to send and receive data simultaneously.