-
I want to install the Katapult bootloader to make it easy to update the klipper firmware, then deploy updates to klipper firmware via katapult. I flashed katapult with the following options:
Enable…
-
### Linux Distribution
There was some problems with connecting of Mainsail to the Moonraker after reinstalling of klipper and mainsail. And after making the Klipper and Moonraker repository rollbac…
-
I've been looking at tuning the drivers and [according to the klipper docs, hold_current should no longer be used](https://www.klipper3d.org/TMC_Drivers.html#prefer-to-not-specify-a-hold_current). How…
-
I saw that Eddy is now supported in mainline klipper so figured I'd update everything with the hopes of it resolving some of my z-offset issues.
After rebuilding and flashing klipper for all of my …
-
Default configuration with commented sections for each feature used / separate config files possibly
- [ ] - Sensorless homing
- [ ] - Microswitch homing
- [ ] - BLTouch
- [ ] - Inductive probe
…
-
### Is there an existing issue for this feature request?
- [X] I have searched the existing issues
### Is your feature request related to a problem?
Z movements when retracting (z-hop) require the …
-
Please evaluate if it is really necessary to use a fork of the Klipper core for the SV08. A superficial inspection of your changes lets me think that this printer could run perfectly well with a pure …
-
In moonraker you can add entries to check for updates.
In this case you can add the following to moonraker.conf and it will track the git or an individual branch.
https://moonraker.readthedocs.i…
-
Hi @g992,
Have you successfully connected the FF A5M board to an external CPU? I'm looking to connect it to a Raspberry Pi 4 running the latest versions of Klipper, Moonraker, and Mainsail. However…
-
When I add the following to the klipper printer.cfg:
[filament_motion_sensor encoder_sensor]
detection_length: 7
# The minimum length of filament pulled through the sensor to trigger
# a sta…