-
Hi, the firmware for kossel linear plus seems to not be correct..
First issue: when probing, it will fail b/c the probe will not go all the way down. Only way to correct this was to set the z-heigh…
-
hello, do you still have the configuration files for Marlin 2.0.8.1 Lerdge K for the Anicubic Kossel printer
-
The focus seems to have been lost on the upgrade of the Kossels' cooling capabilities. This project is actually far from done and needs to be picked up again as soon as #62 is complete!
- [x] design f…
-
I'm very new to this but, I have my Kossel Mini up and running my only problem is it seems if I run the auto-level before I start printing it doesn't do anything because the extruder is running into t…
-
HELLO . I want to congratulate for the software. I got to upload the software afther changing the parameters in configuration.h . The only problem is that i change the steps per unit from 200 to 100…
-
The Kossels have been "expert only" for long enough, it's time to finally fix them! Andrea and Johannes are working on Kossel B at the moment but all Kossel A might need is a more stable piece of shri…
-
My Printer Spec AnyCubic Kossel Linear Plus 2023
MKS-TINYBEE Marlin BugFix2.1.x LayerShift Fix
-TMC2209 x4
-MKS MINI v3.0 SDCARD SUPPORT
-RBG LED
-WIFI SUPPORT
-FIXBUG LayerShift
-Smoo…
-
when i send a
+++AT AP 3Dprinter kossel 1 1
but when i que:
+++AT AP
it prints:
+++AT AP
SSID=3Dprinter PASSWORD=kossel AUTHMODE=0 CHANNEL=1
even after a reset, even after a powercycle it stays tha…
-
We have two different versions of Marlin on the Kossels and Prusas, and four different calibration settings.
- [ ] Find out which Marlin versions the manufacturer versions were forked from (not requi…
-
just wondering if the configuration.h and configuration_adv.h files in the example folders are already setup for the MKS ROBIN NANO v1.2 board with TFT35 V1.3 display? I found them inthe Marlin-bugfi…