-
The stepper motor driver chip supports pulling an internal pin low when certain conditions exist, [page 33 of the datasheet](ttps://www.st.com/resource/en/datasheet/l6470.pdf). It would be advantageou…
-
Can you tell me how to connect GPIO with this board?
https://www.aliexpress.com/item/1564532401.html
Thank you.
-
Hi, while this compiles fine for the esp8266 it doesn't actually work.
What would be required for it to work on ESPs?
There are currently no available library's for the L6470 and yours looks like th…
-
Hi Hendorog
Want to use the 6470, trying to find answers in your code, but on opening crashes
Do you have a fix?
Are you planning to further develop?
Can you send me the 6470 relevant code +pin assi…
-
There is no option for the Raps128 stepper in Configuration.h
```cpp
* Stepper Drivers
*
* These settings allow Marlin to tune stepper driver timing and enable advanced options for
* stepper …
-
I am interested in how you are able to sync two of these L6470's.
With CN work you want to make straight line move between x and y.
Move from X0 Y0 to X10 Y10 is easy
Move from X0 Y0 to X10 Y50 n…
-
i want read Mark Position with easy command like stepper.getMark();
Thanks
-
I have the same motherboard and was looking at your VS code. First question is does it work? I don't have a sensor mounted yet nor do I want filament run-out yet. Something stuck out that you have E2 …
-
- [x] Add support for custom display in build system
- [x] Implement class Display
- [x] Implement class Nextion
- [ ] Implement bridge with remote configuration management
These displays are us…
-
### Describe the bug
The value of the sensor inverter_power is the same as inverter_power1 but it should be inverter_power1 + inverter_power2 + inverter_power3.
![power](https://github.com/wills106/…