-
![111111](https://github.com/user-attachments/assets/cdf22569-826c-4556-95fc-c333ee7201b1)
When laser cutting laser energy should not be in the motor acceleration and deceleration stage output se…
-
Hello, in the paper, on the page 4, you claim to have the laser clouds subsampled to 4mm. But in the downloaded LASA dataset, the resolution is only 4cm. That is unfortunately too sparse for my use-ca…
-
This might be a ddnet bug.
```
sv_destroy_lasers_on_death 0
tune laser_bounce_delay 200
tune laser_reach 4000
tune laser_bounce_num 1000
```
Go to some tunnel and do a wallshot then selfkil…
-
I'm looking at using an alternate laser module that is available very inexpensive on Aliexpress for $30. The TW10S-UART uses UART and will connect to the same 5-pin port that the Egismos connects to…
-
The spindle does not move beyond the starting point. It burns only in one spot. I have downloaded all the custom buttons but cannot get the project to go beyond one point. I am new to this hobby, so…
-
Hi Friends,
Please, is it possible to help me to understand how to do 2D FFT of a laser pulse. The pulse is defined on the spatial grid as ```Ey(x,y)```. I can do 1D FFT (by taking line out of the …
-
Hello,
I have almost finished my laser machine, (see attached jpg.) I have it running but not the laser head just yet. I will be using an air pump and wondering if you have added the control for t…
-
Updated 9/11/24: LaserDiodes.lib is in the attachment
Dug out a Laser Diode simulation I did in the 1990s on a Sony device. I also downloaded some LTspice simulations. Should be useful for someone …
-
-
Dear teacher
I would like to ask how to set the focal position in the EPCOH laser block.
Here are my own settings, but I am not sure if the laser will focus at position x_m after emission, a…