-
### Is your feature request related to a problem? Please describe.
Yes, it is different, for example there is a G code conflict between Linuxcnc and Fanucla.
### Are you looking for hardware sup…
-
## Here are the steps I follow to reproduce the issue:
1. Start a program with the spindle turning
2. Pause the program
3. Stop the spindle during the halt (e.g. for checking surface finish etc.…
-
Hi,
I went through your config. I see you are using position mode for servos. I use the same, but I get crazy following error and I see you set FERROR to 10 as well. Guys at linuxcnc recommend using …
-
When using locale settings for e.g. Germany, so having a "," as decimal point, the tool table shows the correct decimal point after starting.
But after loading an (empty) G-code file and reloading th…
hansu updated
22 hours ago
-
Hello, I'm trying to run your your weeny project on a Raspberry pi 5 using the pre-made linuxCNC distro file from the LinuxCNC website. I'm not sure what is causing the problem but running the hallcom…
-
I just did a package install on a fresh 'bone-debian-7.6-lxde-armhf-2014-08-05-4gb.img'. Linuxcnc fails to run on it. It fails on this line(39) from the Xylotex.hal file:
loadrt [PRUCONF](DRIVER) pru…
-
## Here are the steps I follow to reproduce the issue:
1. open stepconf
2. configure stepper for at least one axis
3. click "test this axis"
4. in the dialog that opens, press *any* button
…
-
I find it uncomfortable if not annoying to have NativeCAM in the same window as Axis UI, positioned side-by-side. Loading NativeCAM together with LinuxCNC every time is also not necessary in lots of u…
-
https://user-images.githubusercontent.com/46067220/136030425-a9814226-0a65-4624-a3b9-0c0c37a73e04.mp4
-
Should we include the linuxcnc config files, and GRBL? https://www.dropbox.com/sh/ntq74n1jne1cqnc/AACZB0VCm-76gnU5na3JdTXla?dl=0