-
Can you please add support for the MAX32660-EVSYS board?
-
Perhaps we can jointly work on this work if you are interested, here is the [max32660-hal](https://github.com/rbkettlewell/max32660-hal) I have worked on periodically.
-
Hi,
Can I ask two questions please?
I own a MAX32660 EVSYS. It is not officially supported in the MaximTechnologies Arduino Boards and Examples.
Currently I'm using the Maxim modified Eclipse…
-
Ideally, if you want to configure an I2C, or SPI peripheral, those modules should check to ensure that the pins being used are setup properly.
https://datasheets.maximintegrated.com/en/ds/MAX32660…
-
I am unable to find any methods to burst read fifo stored data.
The datasheet mentions it here:
```
5 FIFO
The LPS22HB embeds 32 slots of 40-bit data FIFO to store the pressure and temperature
…
-
My quadcopter used this board: https://www.tindie.com/products/onehorse/ultimate-sensor-fusion-solution-lsm6dsm-lis2md/
The creator has spent a good amount of time characterizing the performance of…
-
Hey,
I was running Hello_World example on it But I can't flash my board, it is giving the error:
**Remote communication error. Target disconnected.:**
I am using VS (Eclipse made me too much t…
-
Just a question:
have you ever tested Invensense latest 9DOF chip, ICM-20948, as the sensor for Ultimate Fusion board? One would expect that it could give better performance than 9250, but it would b…
-
I would love to have support for the MAX33660-EVSYS, because it would simplify development a lot.
Using Eclipse and CMSIS API is way more complex and "undocumented" than using Arduino / PlatformIO.…
-
The one you talk about in here: https://github.com/kriswiner/EM7180_SENtral_sensor_hub/wiki/K.-Limits-of-Absolute-Heading-Accuracy-Using-Inexpensive-MEMS-Sensors
I'm working on a robotics project/a…