-
Thanks for you work. Want to make such device, but have question: can I use SPI - CAN converter (MCP2515 and TJA1050)?: https://images.prom.ua/2447555310_w600_h600_2447555310.jpg
or:
https://images.…
-
To use the MCP2551 transceiver with a Teensy LC microcontroller, you can follow these steps:
Step 1: Wiring
Connect the MCP2551 to your Teensy LC as follows:
- VCC to 5V on Teensy LC.
- GND to G…
-
Hello, I am working on a project to using CANBed - Arduino CAN-BUS Development Kit (ATmega32U4 with MCP2515 and MCP2551) to read data from CAN BUS such as RPM and depend on that I want to give command…
-
Hi, I'm trying to interface Materon DST100 with Arduino Mega using this example -
https://github.com/ttlappalainen/NMEA2000/blob/master/Examples/ArduinoGateway/ArduinoGateway.ino
and following thi…
-
Don't currently have hardware control to transceivers to pull low. Update schematic to do so. Attempt on-board wire hack.
> By setting the MCU, the CAN controller (MCP2515) and the transceiver (MC…
-
```
Controller area network protocol.
What type of physical layer transceiver is needed?
```
Original issue reported on code.google.com by `ianles...@gmail.com` on 31 Mar 2009 at 2:34
-
```
Controller area network protocol.
What type of physical layer transceiver is needed?
```
Original issue reported on code.google.com by `ianles...@gmail.com` on 31 Mar 2009 at 2:34
-
```
Controller area network protocol.
What type of physical layer transceiver is needed?
```
Original issue reported on code.google.com by `ianles...@gmail.com` on 31 Mar 2009 at 2:34
-
```
Controller area network protocol.
What type of physical layer transceiver is needed?
```
Original issue reported on code.google.com by `ianles...@gmail.com` on 31 Mar 2009 at 2:34
-
```
Controller area network protocol.
What type of physical layer transceiver is needed?
```
Original issue reported on code.google.com by `ianles...@gmail.com` on 31 Mar 2009 at 2:34