-
Hi pierre,
First of all, thank you for your development of such a powerful library regarding CANFD.
My issue here is that I can't recieve CAN2.0 messages using a innomaker usb2can device. The cod…
-
Hello All,
Thank you for the ACAN2517FD library provided for Arduino uno. I have tried Arduino uno loop-back demo code and configured all Arduino SPI lines to MCP2517FD click module,but below menti…
-
Hello everyone,
Is anyone did interfacing MCP2517FD module with TM4C123gxl(Tiva launchpad) micro controller ?
Please help me if anyone has done this project.
-
ESP32 + MCP2518FD Pro board has errors when connected to can network ** and !!
Setup configures the MCP2518 correctly but when connected to can network I get !! and ** in serial monitor.
In code I…
-
unable to compile:
[ 66%] Building C object CMakeFiles/firmware.dir/main.c.obj
In file included from /pico/micropython/ports/rp2/canis/candrivers/mcp2517fd/mcp2517fd-types.h:23,
fr…
-
Hello, I am trying to use socketcan with your project for my research.
I have connected MCP2517FD to Raspberry PI 3B+ as follows:
GPIO9 -> MISO
GPIO10 -> MOSI
GPIO11 -> SCLK
GPIO8 -> CS
GPIO2…
ghost updated
4 years ago
-
Hi, I used savvycan with the SAM3X8E microcontroller, it was possible to combine CAN0 with CAN1 at different speeds and it worked as CAN gateway, now I use esp32 CAN0 and CAN1 on MCP2517FD works great…
-
I'm trying to use SPI1 instead of SPI0. I'm using the mcp2517fd-spi1.0-can2-overlay but dmesg is giving me CRC errors.
pi@raspberrypi:~ $ dmesg |grep spi
[ 4.065147] mcp25xxfd spi1.0: CRC read …
-
Hi everybody,
I'm trying to run "LoopBackDemoArduinoUnoNoInt" example on Arduino Giga R1 (I was able to run the ACAN2517FD library on Rapsberry Pico).
Each time I open the Serial Monitor the ske…
-
Hi Pierre,
I was successful in using acan2517 lib on Arduino nano with MCP2518FDClick board as sender and UNO with MCP2515 as receiver. I am unable to do the same with pico development board, The p…